Tapco Tape attaches easily to a Tapco Tools brake to provide an instant scale for bends and cut-offs, allowing users to measure from the brake anvil and with a 1.5\u2033 offset for use with the Pro-Cutoff without using a standalone tape measure. With the Tapco Tape in place, there\u2019s no need to mark material with a tape measure and then line up marks with the anvil. It also has material stops to make repeat bends more efficient. The result is easier, faster and more precise bending.<\/p>\n Tapco Tape clamps to the brake without needing to drill holes. The accessory has a hinge design, so users can swing it up and out of the way when not in use, then bring it back down into place when needed.<\/p>\n \u201cSiding and trim fabricators rely on the precision and durability of Tapco Tools brakes to craft custom, on-site trim with a high-quality, expert finish, and Tapco Tape adds to that versatility,\u201d said Steve Booz, vice president, marketing for Westlake Royal Building Products. \u201cRather than fumbling with a separate tape measure and worrying about lining up marks, Tapco Tape simplifies the process, thereby increasing efficiency and accuracy.\u201d<\/p>\n Tapco Tape can be used with the Max-I-Mum XL, PRO 14, PRO 19, Pro II, Pro III, Pro 2000, and Pro 50\u201d Tapco Tools brake models.<\/p>\n \u00a0<\/p>\n \t\t\t\t<\/div>\n![\"-\"](\"https:\/\/www.canadiancontractor.ca\/wp-content\/uploads\/2025\/01\/tapco_tape2.jpeg\")
<\/a>Westlake Royal Building Products<\/a> has launched Tapco Tape, a measuring accessory that speeds custom bends and cuts on Tapco Tools siding and trim brakes.<\/p>\n